The TFT Mid-Force is a truly rugged, dependable, and effective mid-range firefighting nozzle. 

The wide flow range of 70-200 gpm (265-760 l/min) allows the Mid-Force to be used on 1.5" (38 mm), 1.75" (45 mm) and 2" (52 mm) hose. This nozzle is equipped with a low pressure override which allows the nozzle to achieve greater flows at lower nozzle pressures. All nozzles are regulated to 100 psi or 75 psi ±15 psi (7 bar ± 1 bar) according to NFPA #1964 flow requirements. It is adjustable from a straight stream to a dense fog pattern with either molded rubber fixed teeth or stainless steel spinning teeth. Handle covers and pistol grips are available in NFPA colors to identify a nozzle with its discharge (NFPA 1901 (A.16.9.1). All Mid-Force nozzles accept: the FJ-LX-HM, FJ-HM low-expansion, or the FJ-MX-HM multi-expansion foam attachments.

In the standard mode, the Mid-Force Nozzle maintains a 100 psi (7 bar) operating nozzle pressure (75 psi /5 bar for low pressure version). The TFT high level of quality, engineered into all TFT products, allows this nozzle to meet the NFPA #1964 flow requirements for automatic nozzles. This gives you the desired ability to aggressively conduct a hard- hitting fire attack.

With a twist of the knob on the front of the nozzle, you switch to the low pressure mode, which immediately reduces the nozzle's operating pressure to around 55 psi (3 bar) (45 psi /3bar for low pressure version). This exclusive TFT feature provides you with the unique ability to change operating nozzle pressure depending on the situation, thereby allowing maximum flow at a lower nozzle pressure.

HMD-V MID-FORCE NOZZLE 1.5" NH (38 mm) - Automatic with a flow capacity of 70-200 gpm (265-760 l/min). Includes flush without shutting down, patented slide-type valve for turbulence-free flow control, six detent flow positions, and “Gasket Grabber” inlet screen. Lightweight hardcoat anodized aluminum for maximum resistance to corrosion and wear. Nozzle may be switched between standard 100 psi (7 bar) and low pressure. Rocker lug 1.5" NH (38 mm) full-time swivel is standard.

4.5 lb ( 2.1 kg)
11.50 " ( 29.2 cm)

Available in low pressure version:

• TFT-HMDL-V
• Same as HMD-V, but operates at lower pressures of approximately 75 psi (5 bar)/45 psi (3bar)
• Weight: 4.5 lbs (2.1 kg)
• 11.50 " ( 29.2 cm)

• Molded Rubber fixed teeth: TFT-HMD-V, TFT-HMDL-V
• Stainless Steel spinning teeth: TFT-HMDL-VS